CoroCut 1- and 2-edge inserts
– the first choice system | |
Inserts
This system is based on a patented Rail and V-shaped design which, together with a long insert, gives exceptional stability. These factors make it possible to run at higher cutting data and to achieve better productivity than any other system on the market.
The inserts are available in different insert seat sizes covering inset widths from 1.5 mm up to 15 mm, having different corner radii.
The insert seat sizes must correspond with the holder seat size.
Most of the inserts are 2-edged versions in order to give good economy. Note that the maximum cutting depth, ar, for these inserts is limited, see the table. | |
| Insert seat size | Insert width, mm
from | Max. cutting depth, ar, for CoroCut 2 inserts, mm |
| D | 1.5 | 12.9 |
| E | 2 | 19 |
| F | 2.5 | 18.9 |
| G | 3 | 18.8 |
| H | 4 | 23.7 |
| J | 5 | 23.6 |
| K | 6 | 23.5 |
| L | 8 | 28.4 |
| M | 9 | - |
| R | 15 | - |
|
| |
If larger depth is needed, use the 1-edged solution which can cut as deep as the blade will allow.
Geometries
A large variety of geometries are available, dedicated to different applications and feed areas. Select the geometry after application and feed, see the table. | |
CoroCut insert geometries
The first letter in the geometry name represents different application areas.
C | = | Cut-off i.e. Parting |
G | = | Grooving |
T | = | Turning |
R | = | Round insert i.e. Profiling |
A | = | Aluminium machining |
| | The second letter gives information about feed area.
F | = | Finishing i.e. low feed area |
M | = | Medium feed area |
R | = | Roughing i.e. high feed area |
O | = | Optimising i.e. for special areas |
S | = | Sharp edge, extremely low feed area |
E | = | Edge rounded, for special cases |
|
| Code example: |  |
| |
| Geometry designation |
|