| First choice recommendation |
|
Component dia. 1-32 mm
Side turning (not copying)
Insert: VCEX 110301R-F 1025
Holder: SVJBR 1212K-S-B1
Start value: low alloy steel
vc: 150 m/min ap: 2 mm fn: 0.1 mm/rev
|
|
|  |  
 View the small part machining video
|
Insert VCEX
Nose radius: 0 and 0.1 mm
Hand: Available in left and right handed versions.
Grades: 1020, 5015 and H13A
Geometry’s: R-F and L-F
Holders: Fits into any standard holder for VCMT 1103 inserts.
| | Features
The VCEX insert for side turning and back-turning is designed for both small and large cutting depths up to 4mm. The VCEX insert generates an extremely good surface finish, due to the wiper effect. |
Cutting depth
 Feed
Cutting depth: (ap) mm
Feed: (fn) mm/r | |
| 1. | The VCEX insert, due to its design, has a very highedge strength, which enables machining in one pass, resulting in increased stability of the component and reduced cycle times. |
| 2. | It is recommended to run with cutting speed higher than 60 m/min as this will increase the tool life radically. |
| 3. | The VCEX insert makes it possible to generate extremely good surface finish as the geometry has good chip control. |
| 4. | It is recommended to use 1020 as first choice, but for prolonged tool life and for finishing cuts 5015 should be used. |
|
|