Aerospace

Spool The two challenging features of this component are the deep internal chambers and the external blade tulip grooves. A combination of engineered solutions and methodology with optimised grades are the key to success. More engine components Dampened blades with Coromant CaptoŽ To machine the deep internal chambers typically up to 150 mm, long, slender tools are required. The challenges are tendency to vibration as well as removal of the chips from the groove. Turning one of the most challenging features into a secure process has been achieved by: Oval serration blade system for best stability and accessibility. The 100mm high blade allows for best coolant delivery to assist in chip removal For blades longer than 4x width of the blade a patented dampening device is part of the design. This allows depth of cut to be 4 times greater than without dampening Trochoidal turning technique combined with ceramic grade CC6060 reduces the number of machining passes required A secure process with more than double the productivity. More information: Read more about Coromant CaptoŽ system Without dampening Same cutting conditions with dampening Blade groove on spool Inserts to fit every groove shape. To complement the standard CoroCut 90 degree programme, blanks are available in 90,45 degree and T-shape for more special requirements. Angled inserts for aerospace access Grade GC1105 – Designed for the challenge of super alloy machining GC1105 provides secure, reliable, quality machining, even flank wear and is truly versatile in all application areas. Reliability in intermediate stage machining through superior notch wear resistance in combination with good edge line toughness. Guaranteed accurate high quality performance in last stage machining provided by our razor sharp, ground inserts and our state of the art thin coating, with excellent adhesion. Our super alloy solution – GC1105 Animation: Precision machining with GC1105 Ceramic grade CC6060 - an optimizer for increased productivity Excellent resistance to notch wear allowing for higher depths of cut to be taken compared to other ceramics Long lengths of cut Profiling and pocketing using trochoidal turning Read more about CC6060 RCMX turning inserts for finishing Carbide RCMX insert fits in same insert pocket as ceramic, reducing number of tools required and set up time The geometry provides low cutting force and good chip control S05F for HRSA or H13A for titanium

© Sandvik Coromant Latest update: 09/16/2010 04:15:02 PM Print this page | Send this page | Legal notice | Site map | Contact us | Comment this page