-English -EN Settings

Settings

Please select your country!

{{group.Text}}

{{"ifind_go-back" | translate}}

{{group.Text}}

Cutting data for parting and grooving

Cutting data for parting and grooving
 

Speeds and feeds for parting and grooving

  • Use correct feed rates for the insert and material
  • Start at a low feed rate to ensure insert security and surface finish, then increase feed rate to improve chip breaking
  • Run at a cutting depth larger than the corner radius if side turning. This will improve chip control
  • Setting the cutting speed too low will result in inadequate tool life. Always run recommended cutting speed, vc m/min (ft/min)
 

{{getHeaderText()}}

 
We use cookies to enhance the experience on our website. More about cookies.