What is reaming?

General hints on reaming

To obtain the best results when using reamers it is essential to make them ‘work’. It is a common fault to prepare holes for reaming with too little stock left. If insufficient stock is left in the hole before reaming, then the reamer will rub, quickly show wear and will result in loss of diameter. It is equally important for performance not to leave too much stock in the hole.Read more about stock removal

• Select the optimum type of reamer and the optimum reaming speeds and feeds for the application. Ensure that the pre-drilled holes have the correct diameter
• The workpiece must be held rigid and the machine spindle should have no play. Read more about Workpiece set-up
• The chuck must be of good quality. If the reamer slips in the chuck and the feed is automatic, breakage of the reamer may occur
• Keep the tool overhang from machine spindle to a minimum
• Use recommended lubricants to enhance tool life and ensure that the fluid reaches the cutting edges. As reaming is not a heavy cutting operation, soluble oil with 40:1 dilution is normally satisfactory. If dry machining, air blasting may be used with grey cast iron. Read more about Cutting fluid
• Do not allow the flutes of a reamer to become blocked with chips
• Before the reamer is reground, check concentricity between centres. In most cases only the bevel lead will need regrinding
• Keep reamers sharp. Frequent regrinding is good economy, but it is important to understand that reamers cut only on the bevel and taper leads and not on the lands. Consequently only these leads need regrinding. Accuracy of regrinding is important for hole quality and tool life