EasyFix sleeves are a solution for cylindrical boring bars reducing set-up time. A spring plunger mounted in the sleeve clicks into a groove in the bar to guarantee the correct centre height.
The slot in the cylindrical sleeve is metallic sealed which allows the existing coolant supply system to be used. The metallic sealing offers good performance also for high coolant pressure.
Benefits
- Fast set-up time
- Simple to use
- Extended tool life
- Excellent surface finish
- Correct cutting edge centre height and position
Features
- Spring plunger solution (spring loaded ball) in the sleeve and the bar groove gives correct centre height of the insert every time you make a tool set-up.
- Metallic sealing offers good performance for coolant pressure up to 150 bar (2200 psi).
Application
The EasyFix sleeves fit a wide range of products:
Do not use EasyFix sleeves for boring bars with flats, as you won’t attain the advantage of finding the correct centre height of the bar without the groove. A bar with flats normally clamps with screws from the top and locates on the flats of the bar.
When using a clamping set-up, tighten the screw closest to the front of the tool first for best rigidity and clamping effect.
Tool set-up
The tool set-up has a strong influence on the thread quality and effectiveness of... chevron_right
Tips and tricks
Tips and tricks Congratulations to your new start-up tool kit. Now, it’s time to... chevron_right
Tool set-up
Good quality in parting off and grooving is mainly dependent on the tool system and... chevron_right
CoroBore® 820 XL
CoroBore XL is the boring tool system for large diameter boring. The bridges and... chevron_right
